Figure 2 Remove the single Philips head screw from each handle (red arrow). Figure 3 Insert your trim removal tool between the panel and hatch (red arrow). Figure 4 Pull the panel down while moving along the edges (red arrow). The clips holding the panel in place are very strong. You will need to use a fair amount of force to get them to release.
Download Article. 1. Lift the door latch and remove the screw attaching it to the panel. Hold the door handle latch open and look for a fastening screw at the base of the latch. Take a screwdriver and remove the screw. Set the screw aside so you don’t lose it. [1]Looked loads on 'net only found stuff on door panels. Despite parking sensors I reversed very slowly into a metal bar and gave it a bit of a biff, took some doing but 'I managed it' (!). Caused dent in the hatch / tailgate crease, level with the VW release button, pulled the most of the dnet out, just leaving vertical crease in the hatch.
Pull door trim -1- upwards vertically out of window slot seal. Disconnect the electrical plug-in connections from the door trim -1- in accordance with the vehicle's equipment. Unhook Bowden cable -1- from inner door handle. Before installing, check all fasteners for damage and renew if necessary.
This video will show you how to remove your Rear Side Panel (Cabriolet models) on your Audi A4, S4 or RS4 (B6, B7) 2001-2008. Sometimes also (incorrectly) r
Vw Golf Mk4 Door Panel Removal. H4 Torque. 12.7K subscribers. 52K views 6 years ago. Removing door panels of a mk4 golf Vw Golf V6 4Motion Go Pro hero 4 more. more.This is a step by step guide for removing and installing the door panel on your 4th gen Firebird or Camaro. Roll window all the way down and remove disconnect the negative battery cable. Remove the window/lock switch by getting your fingers under the top and bottom and lifting straight up. You can use a flat head screwdriver, but make sure you .